USR8500 USB ADSL Modem

(USR998500)

USR8500

FAQs en inglés

  • Información sobre reparaciones
  • My computer did not recognize the modem.
  • The drivers are installed, the power LED is ON, the phone line is connected, but the data light is off or keeps flashing.
  • Configuring the TCP/IP Settings.
  • Uninstalling the Modem.

    • Ayuda Adicional

    Si la información de la ayuda en esta sección no le ayuda a solucionar su edición, envíe un mensaje de correo electrónico a un técnico de asistencia de USRobotics.

    		Nota: Para prevenir a su navegador de su intención de descargar este software, haga clic derecho en el enlace que lleva al fichero y seleccione Guardar destino como... (Save Target As...)

    Archivos útiles que puede descargar

    Controladores

    Windows 98, Me, y 2000 Controladores
    This zip file contains the drivers for the USRobotics USB ADSL Modem. Follow these steps to install the drivers:
    1. Download the usb-adsl-drivers.zip file to a temporary location on your computer’s hard disk drive such as C:\temp.
    2. If you have not already done so, connect the modem to your PC using the provided USB cable and connect the RJ-11 phone cord to the DSL jack on the ADSL Modem.
    3. Windows will automatically detect the USB ADSL modem and launch the Add/Remove Hardware Wizard. Select the location to which you extracted the contents of the usb-adsl-drivers.zip file and click Next. Follow the prompts to complete the installation.
    4. Configure the DSL software settings using the required settings provided by your DSL Service Provider. Refer to the USB ADSL Modem Manual for further assistance, if needed.
    usb-adsl-drivers.zip3.19 MB 26-06-01

    Beta versión for Macintosh

    Nota: Instalación para MacOS desde la versión 8.6 a la versión 9.2.2.

    Follow the directions below to download the drivers.

    1. Double-click the driver and unstuffit. The main folder will appear.
    2. Click the main folder and click DSL Modem Install_EN Disk.
    3. Click Installer and follow the instructions.
    4. Connect the modem to your computer using the provided USB cable and connect the RJ-11 phone cord to the DSL jack on the ADSL Modem.
    Nota: Shortly after the modem is plugged in, the Power and Data LEDs should start blinking. To verify the ADSL connection, click Control Panel and then ADSL Setup. DSL connection information will appear.

    USRobotics is providing this beta driver set as is and is currently offering limited support, staying consistent with the drivers on this page

    USR_3Mbps_1.1.0008Q.sea.hqx1.37 MB03-06-02

    Firmware

    En este momento no están disponibles.

    Asistencia técnica por correo electrónico Envíe un mensaje de correo electrónico a un técnico de asistencia de USRobotics.

    Registro de garantía Active en linea la garantía de su producto USRobotics.

    Contactos Internacionales Hage clic anqí para obtener asistencia técnica por país.